HOMEOWNERS: 750 sq. ft. minimum to receive a quote or sample.
Endwall flashing is installed on a vertical wall and then fastens to the top of the metal roofing panel. It's located on the upward slope of the roof and is bent to the same pitch. The purpose of endwall trim is to help control the flow of water which will protect your structure. It can be installed with or without a reglet trim.
This parts list is designed to help you calculate the quantity of accessories that you’ll need for your trim installation. It has all of the accessories that are needed to install 1 full piece of trim, which is 120" long. To calculate the total number of accessories you will need for your job, simply take the number of trim pieces associated with the trim part purchased and multiply the list by that number for a total for your project.
A reglet trim may also be required.
To begin, please note that if your roof has a sidewall condition, all sidewall trim must be installed prior to fastening the endwall.
Step by step video that covers installing endwall flashing on a metal roof which includes: cutting and finishing at the sidewall, overlapping, foam closure installation, and fastening. This video is for installation of an exposed fastener panel.
To begin, please note that if your roof has a sidewall condition, all sidewall trim must be installed prior to fastening the endwall.
This step by step video is specifically for an endwall flashing installation with an awning, This video is for installation of an exposed fastener panel.
Fasteners for metal roofing and wall panels.
Inside and outside foam closures for metal roofing.